- Robotic benders ex-Opton, ideal for long-sized work pieces with small diameter
- Labor-saving system for bending a work piece with nut pre- mounted
- Innovative production proposal to implement N/C positioning in a car tire-wheel assembler
- Successful case of Cut-Off 1D Bender
- Tooling set-up time reduced by 83% ( a case of client S)
- ECOBender managed by TIF controller
- Robot Bender for machining speed 160% and fully automatic loading/unloading of work piece compared with standard CNC benders
- Employment of roll wiper to enhance quality stability, reduction of defection rate and running cost (Client ：F)
- Per-space machining efficiency of pipe bending enhanced by doubled or tripled
- Proposal fully satisfied for SW type pipe Bender (Left & Right Bending) (Client:: A Co.)
Case of Innovative solutions
ECOBender managed by TIF controller
2012.08.27
The TIF, Opton's original and general purposed software for NC machineries, has been built in ECO bender series.
Upon time-/flow-chart data entered in the TIF, necessary software are automatically called up and perform to build
and tune proper setting in an operation panel for On/Off of NC drive, axial-synchronization and control, sequence On/Off, etc..
The TIF, Opton's original and general purposed software for NC machineries, has been built in ECO bender series.
Upon time-/flow-chart data entered in the TIF, necessary software are automatically called up and perform to build
and tune proper setting in an operation panel for On/Off of NC drive, axial-synchronization and control, sequence On/Off, etc..
Inquiry and/or consulation
Contacts are most welcome to Opton/MiiC sales group at following telephone number.
America：+1-734-453-2188
Mexico：+52-55-5203-3027
German：+49-89-540165-12
Japan：+81-561-48-3382
Sales affiliates of Opton group
We have sales locations in USA, exico,Germany and HQ in Japan.
