2012.08.18
≪Point of solution≫
1.Tact time cut in prouction is hard to achieve with new product design
2.Machining interference and insertion of extra machining process are unavoidable with standard bender.
3.Hard to design a full automated manufacturing system.
*Hard to enhance the machining speed including those of peripherals.
Longer time is needed for bending processes and no further cost cut is hard to make.
*High output of failure product is very likely.As a right hand bender cannot cover full bending points,
a work pieces needs be manually set on the left hand machine with higher possibility of loading of a work piece in an incorrect set position.
≪Points of solution≫
Switching bender type 25
・The bender of the latest version with Opton's leading edge NC technologies built-in.2seconds only needed per bend.
・All right & left bending are fully performed at one-time chucking, thus ideal for automated production.
・Unloading of a finished work piece & loading of a following piece are processed simultaneously, thus eliminating idle time.
・For tact-time saving, machining process is fully reversed between each work piece automatically
so the idle time from loading to the first bending can be saved for every new work piece.
≪Resulted advantages≫
Cost-cut
・Tact-time improved by 1.4~1.8 times faster than that of standard bender.
・Time-saving is realized by starting machining in reversed process with initial loading of a work piece
to the first bending being executed without loading position change on the bending head.
Enhanced quality of products
・All right & left bending are performed at one-time chucking, in full automation,
the machining can secure enhanced accuracy of products at free from repositioning -related failure.
Inquiry contact