Followings are the partial listings of Opton proposals made for innovative solution. Various solution are proposed for more energy-saving, labor-saving & shorter machining time etc.
【By conventional way of bending】
・A work piece of small diameter (mainly φ5~φ6) and long size (of longer than 1500 ~2000mm)is normally machined by c...
The case described herein shows a very successful solution of problem not on pipe bending, but on assembly line. There are two main assembly-work area...
The TIF, Opton's original and general purposed software for NC machineries, has been built in ECO bender series. Upon time-/flow-chart data entered in...
≪Point of solution≫1.Tact time cut in prouction is hard to achieve with new product design2.Machining interference and insertion of extra machining pr...